Focal Cross Uniq Notice page 2

2
Fixing and wiring
The Cross Uniq crossover has holes to enable its fixing to a flat surface. In order to fix it in
place, we recommend you follow the below steps:
- Remove the 4 screws from the transparent plate, and then remove the plate.
- Place the crossover in the desired place, then mark the position of the holes with a marker.
- Remove the crossover, take a drill and a drill bit of a diameter which must be under 20mm.
Before drilling the previously marked hole positions, take care not to drill the petrol tank or
any other part of the car where any type of wiring may be located.
- Drill.
- Attach the crossover with the screws provided.
- Connect the positive and negative wires from the loudspeaker output of the amplifier taking
care to respect the polarity (+ to IN+ and – to IN-).
- Connect the wires coming from the woofer on the W+ and W- outputs of the Cross Uniq
taking care to respect the polarity.
- Connect the wire coming from the tweeter on the T+ and T- terminals of the Cross Uniq
taking care to respect the polarity.
Note
The N°7 Utopia Be kits include a 3" midrange driver. The wiring polarity of these transducers
depend on the use. When demonstrated on a baffle (all the transducers are on the same
panel) in a sales area for example, you must respect the wiring polarity (+ to MID+
and – to MID-). On the contrary, when installed in a car (please refer to diagram N° 2),
you must reverse the polarity (+ to MID- and – to MID+). This is due to the location of the
transducers which are out of the listening axis.
- Reposition the transparent plate, then put the 4 screws in place.
Adjustment
The Cross Uniq crossover has a 0/+3dB switch which enables you to adjust the level of the
tweeter. We recommend making some successive listening trials at different musical styles to
find the tweeter level most suited to you.
Cross Uniq User 's Manual