A.1.2 Upsilon2000; A.1.3 Battery And Fuse - Atlantis Land OnePower A03-S1001 Manuel

site wiring fault
indicator is lit.

A.1.2 Upsilon2000

Situation
How to install
the
UPSilon2000.
PC doesn't
find the UPS.

A.1.3 Battery and Fuse

Situation
Backup time
Wich type of
battery does
UPS use?
How often do I
have to
change
battery?
Where can I
find batteries?
How can I
check the
Fuse?
Fuse
specification.
neutral wire reversal.
Once started the UPS you can connect it to PC through USB
cable. At this time the SO detects and installs automatically all
drivers. Now you can install UPSSILN2000 on the PC.
1. Check if the cable is properly connected
2. Use the original cable
3. Launch Upsilon2000, then click on INSTALLATION and
check that TYPE OF COMMUNICATION is (USB).
The battery backup time (sometime called battery reserve
time or battery autonomy) is the length of time the battery will
supply power to the load during a power failure. You can
check on the Appendix Backup Time.
2*[12VDC- 7A/h] (A03-S1001)
2*[12VDC- 9A/h] (A03-S1501)
Atlantis recommends to replace the batteries once a year.
1. please contact Your reseller.
2. please contact directly Atlantis Land.
Check the fuse to be sure it is not blown or damaged. Also,
make sure the fuse makes good contact and is not loose in
the fuse holder. Ensure that you are using the correct size
fuse. If you replace the fuse and the UPS again blows the
fuse, please contact Atlantis Land.
[10A, 250Vac](A03-S1001) / [15A, 250Vac](A03-S1001)
You can found on the rear panel (AC Fuse holder) a fuse.
A03-S1001/A03-S1501
OnePower Line Interactive UPS (EN)
Solution
Solution
wiring.
Pag. 26