Omega Wheel Arm 92100 Manuel D'utilisation Et Liste De Pièces page 4

Assembly (con't)
6. Tighten the remaining M8 x 1.25 x 25 Socket Head Screw in the middle hole to remove any slack.
(Refer to Fig 5.)
7. Place the Magnetic Tool Tray on the top of the Front Plate for convenient small part storage.
(Refer to Fig 6.)
Figure 5: Placement of the
M8 x 1.25 x 25 Socket Head Screws.
WARNING
!
• Study, understand, and follow all instructions before
operating this device.
• Do not exceed rated capacity.
• When not in use, rotate support arm so that it rests
against the 2-Post Lift beam.
• Do not lower lift with wheel on Omega Wheel Arm™.
• Ensure all bolts are tightened before use
• No alterations shall be made to this product.
• Only attachments and/or adapters supplied by the
manufacturer shall be used.
• Failure to heed these markings may result in personal
injury and/or property damage.
Figure 6: Placement of the
Magnetic Tool Tray.
4