Norge 10050871 Manuel D'opération page 3

CUTTING AND C
Installation of the Cutter
Assemble the handle set to the cutter
base with provided screws as shown.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
Straight Cut
Insert the floor plank between the
cutting blade and the base, flush with
the guide bar on the working table and
hold the plank then pull handle down
to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
45° Cut
Position the guide bar at 45°. Insert the
floor plank between the cutting blade
and the base, along with the guide bar
as shown, then pull the handle down to
complete a cut.
Note:
Some of 45° cuts may need two cuts: a
straight cut first and then the angle cut.
3