Longshine LCS-FS9124-A Guide D'utilisation page 5

Station Connection
Connect each station to the switch by twisted-pair cable. Plug one
RJ-45 connector into a RJ-45 port of the switch, and plug the other
RJ-45 connector into the station's network adapter. Power on the
switch and then system is ready.
For cable selection, refer to the following table.
Switches Connection
In making a switch interconnection, you could use any port to
connect another switch with straight or crossover cable. As all the
ports support auto MDI / MDI-X function, using a straight cable to
make a switch-to-switch connection is allowed.
For cable selection, refer to the following table：
Network Speed Cable Type
10Mbps Cat. 3, 4, 5 UTP/STP
100Mbps Cat. 5 UTP/STP
Rack-Mount
Rack-Mount Installation (Rack-mount kit is optional for 13-inch
model)
The switch may standalone, or may be mounted in a standard
19-inch equipment rack. Rack mounting produces an orderly
installation when you have a number of related network devices.
The switch is supplied with two optional rack mounting brackets and
screws. These are used for rack mounting the unit.
Max. Length
100 meters
100 meters
4