Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
UM-01 USB microphone
Item no. 31 45 89
Intended use
The microphone is intended to convert acoustic signals (sound waves) into electrical signals.
The USB connector may be connected only to suitable USB ports of computers or game
consoles.
The product may only be used indoors, never outdoors. Do not expose the product to damp, e.g.
in damp locations or the like.
Any use other than that described above could lead to damage to this product and involves the
risk of short circuits, fire, electric shock, etc.
The safety instructions must be observed at all times.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions. We do not assume any liability for any resulting
damage.
We shall not accept liability for damage to property or personal injury caused
by incorrect handling or non-compliance with the safety instructions. In such
cases, the warranty will be null and void.
The exclamation mark symbol indicates important information in these opera-
ting instructions. Please read all the instructions before using this device; they
contain important information on its correct operation.
• For safety reasons, any unauthorised conversion and/or modification to the product is not
permitted.
• When connecting the microphone, pay attention to the safety instructions of the device to
which it is to be connected.
• Do not expose the microphone to high temperatures, strong vibrations or drips or water spray.
• Don't leave packaging materials lying around carelessly; they maybe become a dangerous
plaything for children.
• If in doubt about how to connect the product correctly, or should any questions arise that are
not answered in these operating instructions, please contact our technical advisory service or
another specialist.
Getting Started
Never point the microphone at the sound exit of loudspeakers, since this may
lead to acoustic feedback, which could damage the loudspeakers and the con-
nected computer or game console.
• Switch off the microphone, using the ON-OFF switch on the shaft (push downwards).
• Turn down the volume of your computer or game console (if possible).
• Connect the USB plug of the microphone cable to a free USB port of your computer or your
game console.
• Wait until your operating system has recognised and installed the new hardware. This takes
place automatically.
• Select the microphone as input source in your operating system or your recording software, or
enable the microphone input of your game console, if required.
• Push the switch on the microphone shaft upwards to switch the microphone on.
• Speak into the microphone and adjust the volume via your software as desired.
• After each use, disconnect the microphone from the computer or the game console by remo-
ving the USB plug.
Disposal
Electronic devices are recyclable waste materials and must not be disposed of in
the household waste!
Dispose of an unserviceable product in accordance with the relevant statutory
regulations.
Technical Data
Connection
Frequency range
Sensitivity
Version 01/13
Directional pattern
°
Connection cable
Frequency response and directional pattern
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
USB 2.0 or higher
50-13000 Hz
-55 dB
Cardioid
3 m
Publicité
