English - Johnson Pump SPX FLOW AirV IB-911 R03 Manuel D'instructions

> English
AirV Extra Heavy Duty Radial Blowers
Features
• Tough reinforced thermoset plastic housing
• Mounts on any flat surface
• Slip-on inlet ducting connection
• Efficient high volume air flow
• Low current draw
• Corrosion-resistant materials
Technical Description
Part description
Blower housing and blower wheel
Screws and motor shaft
Motor kit
Waste handling / material recycling
At the product's end of life please dispose of the product according to applicable law. Where applicable
please disassemble the product and recycle the parts material.
Electrical connection
Wiring: Use stranded copper wire. For lengths up to 25 feet (7.62 m) from the power source use 2mm
(12 AWG) or 2.5 mm
2
The pump must be installed according to ISO 10133 (Small craft - Electrical system - Extra low voltage
DC installation for continuous current). Note: The fuse must be ignition protected. The wire connections
must be sealed with a marine sealant or sealed cable connectors.
Note: Before installation with electrical control systems, check that equipment to be used is of sufficient
rated capacity to accept ampere draw of motor. Low voltage will cause motor to overheat.
Wiring dimensions
Max wire length in m*
Wire size
mm
2
12V
1,5 6,2
2,5 10,5
4 16,5
6 25,5
10
16
25
* The wire length is the total distance from the battery to the fan and back to the battery.
It is recommended to use a relay to shorten the main leaders.
Suggested fuse sizes
Capacity
280 m (163 cfm)
3
550 m (324 cfm)
3
750 m (441 cfm)
3
1000 m (589 cfm)
3
6
Material
Nylon pa66
Stainless steel
(10 AWG) wire for 12V and 1.5 mm
3-280
24V 12V
21,7 2,4
36,8 3,7
57,8 5,7
8,3
14,2
22,5
Volt Fuse
12V 5 Amp
24V 5 Amp
12V 15 Amp
24V 10 Amp
12V 20 Amp
24V 15 Amp
24V 20 Amp
To be disposed as
Rigid plastic
Metal/Stainless steel
Electronic waste
(16 AWG) wire for 24V.
2
4-550
24V 12V
7,5
14,5 2,3
20 3,5
30 5,2
8,5
13,8
21
4-750 4-1000
24V 24V
4,6 3,2
7,6 5,4
12,5 8,7
18 13
30 22
35
Original instructions
2