Publicité
Les langues disponibles
Les langues disponibles
Transmitter (controller)
Pack contents:
Lamp holder×1; kinetic transmitter×1; one adhesive pad×1; user manual×1; screws×2.
Installation:
Note:
1. Please confirm that you have turned off the power before removing or changing the switches.
2. The metallic wall plate will decrease the operating range.
a. Lamp holder:
1. Turn off the power. Screw the E27
bulb into the lamp holder tightly.
2. Connect the lamp holder with yours.
b. Transmitter:
1. Set up with screws
1). Open the transmitter with your hands.
2). Use the screws to mount.
3). Reconstruct the transmitter and finish.
Instruction Manual
Receiver (Bulb holder)
Important
1. Do not get the lamp holder wet.
2. Do not disassemble, repair or modify.
3. Please screw securely.
4. Do not exceed the electrical ratings.
5. Load power: 150w
GB
Publicité
