NUU GARDEN AH002 Mode D'emploi page 5

1. Attach wheel assembly (I) to base (H). Line up holes
in wheel bracket with corresponding holes in base, insert
two bolts M8 x 16 (BB) through holes, and finger tighten
two M8 flange nuts (AA). Be sure that the wheel assembly
is parallel to the base, and fully tighten bolts.
Hardware Used
AA M8 Flange nut
x 2
BB
Bolt M8 x 16 x 2
2. Attach three support brackets loosely to base with
three bolts M8 x 16 (BB) downward through support
brackets into the Base.
Hardware Used
BB
Bolt M8 x 16 x 3
3. Install post onto three support brackets. Attach
post to support brackets using six bolts M6 x 30
M6 flange nuts. Fully tighten all of the screws.
Hardware Used
CC
M6 Flange nut x 6
EE
Bolt M6 x 30 x 6
ASSEMBLY INSTRUCTIONS
1
H
BB
AA
I
2
BB
3
& six
EE
CC
4. Load Cylinder Housing onto Post.
Slide Cylinder Housing down.
5. Attach reflector spacers (FF) and Ø8 washers(GG) to
the top of head assembly (B). Tighten the reflector
spacers (FF).
Unscrew stainless steel bolts (DD) from head
assembly (B).
Hardware Used
GG
x 3
Reflector spacer
FF
x 3
DD Stainless Steel Bolt x 4
6. Insert hose of head assembly (B) into post (F). Secure
head assembly (B) to post (F) with stainless steel
bolts (DD).
Note: The control knob on head assembly (B) should
be above the decal on post (F).
Hardware Used
DD Stainless Steel Bolt x 4
ASSEMBLY INSTRUCTIONS
4
5
FF
GG
B
6
DD