Table Des Matières - Clarke OBS-18DC HDTR Manuel De L'utilisateur

ENGLISH EN
Operator Safety Instructions ............................................................................... 3
Introduction and Machine Specifi cations ............................................................ 4
Machine Transportation ...................................................................................... 4
Machine Set-Up .................................................................................................. 5
Operating Instructions ........................................................................................ 7
Troubleshooting .................................................................................................. 8
Sanding Cuts and Sandpaper ............................................................................ 9
SECTION II Parts and Service Manual
Base Assembly ............................................................................................28-29
Motor Assembly ...........................................................................................30-31
Handle Assembly .........................................................................................32-33
Electrical Schematics ....................................................................................... 34
WARNING!
The Products sold with this Manual contain or may contain chemicals that are known to certain governments (such as the State of
California, as identifi ed in its Proposition 65 Regulatory Warning Law) to cause cancer, birth defects or other reproductive harm. In
certain locations (including the State of California) purchasers of these Products that place them in service at an employment job site
or a publicly accessible space are required by regulation to make certain notices, warnings or disclosures regarding the chemicals
that are or may be contained in the Products at or about such work sites. It is the purchaser's responsibility to know the content of,
and to comply with, any laws and regulations relating to the use of these Products in such environments. The Manufacturer disclaims
any responsibility to advise purchasers of any specifi c requirements that may be applicable to the use of the Products in such
environments.
-2- FORM NO. 70403B
Contents of this Book
®
American Sanders Operator's Manual (EN) - OBS-18/18DC HDTR
Clarke
revised 6/12