Daytona HELMETS A2 Manuel D'instructions page 5

EN
DAYTONA A-2 INSTRUCTION MANUAL
Welcome
Congratulations and thank you for purchasing a
DAYTONA A-2 device. This Bluetooth device
has been especially designed to keep you
connected to your phone and listen to your
favourite music while travelling on your scooter
or motorcycle.
The DAYTONA A-2 system is compatible with
all Bluetooth devices that transmit audio (mobile
phones, smartphones, GPS navigators and
other devices) using the profiles specified in the
manual. This device is wholly integrated into
your helmet. It can be operated and paired
easily through a single control button (1B or 6A).
A single red/blue LED indicator (6C) serves to
display connection status, pairing, battery
charging and low battery. Use of the DAYTONA
A-2 device, please read this manual and keep it
in a safe place.
Charging the DAYTONA A-2
After Installation, before using your DAYTONA
A-2 device for the first time, you must charge
the device completely. Connect the terminal
(6D) to the provided USB cable (5) and then
connect the cable to a USB charging port. While
charging, the red LED light will switch on (6C)
and it will switch off once charging has been
completed. NOTE : Don't pull off the cable to
disconnect it from the USB port. NOTE : As time
goes by, batteries gradually lose their charge.
This is why it's important to charge the battery
fully before using the device and allow the
battery to use almost all of it's charge in between
charging cycles. NOTE: If you decide to charge
your Bluetooth device prior to installation, make
sure the Speaker Assembly Cord (3) is plugged
into the Bluetooth Module (6).
WARNING :
If you plan to store your DAYTONA device for a
long period of time, be sure to recharge it at least
once every six months to ensure perfect battery
function.
Linking/Pairing
To use the BT device, it's necessary to pair it to
the Bluetooth device you wish to connect it to
(mobile phone, GPS navigator). While the
device is switched off, hold the control button
(1B or 6A) until the LED indicator (6C) begins
flashing in Red and Blue. The mobile phone or
GPS navigator will find the device under the
name SMK A-2. Select the SMK A-2 device and
it will pair automatically.
NOTE : Pairing is a process that only needs to
be completed once. When the Bluetooth device
is paired to a specific device, both devices will
connect automatically when switched off and
on.
Switching ON/OFF
Switching on: press and hold the button (1B or
6A) for a few seconds until the speaker provides
an acoustic signal and the LED indicator (6C)
begins to flash in Blue.
Switching off: press and hold the control button
(1B or 6A) for a few seconds until the speaker
provides an acoustic
indicator (6C) begins flashing in red before the
device powers off.
Call Functions
When there is an incoming call, the speaker will
provide an acoustic signal.
pressing the button (1B or 6A) : press the control
button (1B or 6A) only once Answering through
a voice command: answer the call by speaking
any word out loud (e.g. "Answer!") Ending a call:
press the control button (1B or 6A) only once or
wait until the other person hangs up. Rejecting
5
signal and the LED
Answering by