LiteHawk RANGER Manuel D'instructions page 4

Quick Tip: always tu Quick Tip: always turn the transmitter on first and
off last. off last.
LiteHawk RANGER - Controller Functions
On/Off Power switch: PUSH AND HOLD, red light should come and flash when turned on. Make sure
to turn your hand-held unit on before plugging in the hovercraft.
Throttle control: Moving the stick up increases power and will result in forward thrust. Lowering the
throttle stick will result in reverse thrust. TIP: This is the same stick you will use to "sync" your hover-
craft.
Directional control: Moving the stick to the left will turn the hovercraft left or counter-clockwise.
Moving the stick to the right will turn the hovercraft right or clockwise.
NIMH Battery and Charger Instructions:
Your LiteHawk RANGER comes with a NIMH battery and a USB charger.
Battery: The rechargeable 9.6V NIMH battery provides the power to propel your model.
You should expect 7-10 min run time. Extra batteries are available at www.litehawk.ca.
- The hovercraft is suspended by a cushion of air, because of this if the battery is run
down to low it will stop creating lift. To warn you there is a low battery warning. If you
hear an alarm notification, drive your model to a safe place. Walk over, turn it off and
unplug the battery from the hovercraft.
To Charge: Plug the USB into a USB wall plug adapter (not included). The LED light will
light up when connected to the power.
- Plug the 9.6V battery into the charger. The LED light will blink when charging normally.
- The battery can take up to 4.5 hours to charge. When finished charging the LED will
stop flashing.
- Never dead short a NIMH battery!
- You must FULLY charge the battery before using your new model.
- Do not leave the battery plugged into the model when it is not being used.
- Keep the battery dry.
- Quick Tip! LiteHawk replacement batteries and a quick charger will speed up the wait
time between charges! Visit us at www.litehawk.ca
LED Power Light
Throttle
Power Switch
press and hold
Directional Control