Glacier bay HD58101-X5110H Guide D'utilisation Et D'entretien page 7

Installation
6-Option 2
Tape Installation
□
Push the top side of the slide bar onto the
connector (B), place the bottom part of the slide bar
to the seat (E1) and rotate clockwise to secure the
bottom side tight to the seat (E1).
□
Tighten the set screws(DD) to lock the slide bar to
the connector as below.
NOTE: You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
B
E1
7
Installing the showerhead
□
Insert the rubber sealing washer (D1) into the end
of the showerhead connector and install the
showerhead (D) by twisting clockwise onto the
pipe (A).
CC
DD
A
D1
D
6-Option 3
Screw Installation
□
Push the top side of the slide bar onto the connector
(B), place the bottom part of the slide bar to the seat
(E1) and rotate clockwise the bottom part of the slide
part to secure the bottom part tight to the seat (E1).
□
Tighten the set screws (DD) to lock the slide bar to
the connector as below.
NOTE: You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
B
E1
8
Installing the hose
□
Insert one of the rubber sealing washers into the
end of the hose connector (G) and hand tighten to
the hand shower (F). Hand tighten only.
□
Insert sealing washer into the other end of hose
connector (G) and hand tighten to the outlet
connecter on the slide bar (E) as shown below.
7
Please contact 1-855-HD-GLACIER for further assistance.
CC
DD
F
G
HOMEDEPOT.COM
E
G