Kiwi KHT-8409 Mode D'emploi page 4

SAFETY INSTRUCTIONS
By ignoring the safety instructions the manufacturer can not be hold responsible for the
damage.
• Do not use this appliance with a damaged cord or plug or when the appliance has
malfunctions, or has been damaged in any manner. To avoid a hazard make sure that a
damaged cord or plug will be replaced by an Competent qualified repair service(*). Do not
repair this appliance yourself.
• Never move the appliance by pulling the cord and make sure the cord can not become
entangled.
• The appliance must be placed on a stable, level surface.
• The user must not leave the device unattended while it is connected to the supply.
• This appliance is only to be used for household purposes and only for the purpose it is
made for.
• To protect children against the dangers of electrical appliances, please make sure that you
never leave the appliance unattended. Therefore you have to select a storage place for the
appliance where children are not able to grab it. Make sure that the cable is not hanging in
a downward position.
• To protect yourself against an electric shock, do not immerse the cord, plug or appliance in
the water or any other liquid.
• The heater must not be located immediately below a socket-outlet.
• Installatie instructies moeten worden gegeven.
• Do not use the appliance with a programmer, timer, separate remote-control system or any
other device that switches the heater on automatically, since a fire risk exists if the heater is
covered or positioned incorrectly.
• In order to avoid overheating, do not cover the heater.
• Please do not install the appliance close to curtains and other combustible
materials. This could cause a fire.
• The appliance shall, under no circumstances, be covered with insulating material
or similar material.
• Regulations concerning the discharge of air have to be fulfilled.
• Joists, beams and rafters shall not be cut or notched to install the appliance.
• The heater must be installed at least 1,8m above the floor.
* Competent qualified repair service: after sales department of the producer or importer or
any person who is qualified, approved and competent to perform this kind of repairs in order
to avoid all danger. In any case you should return the appliance to this repair service.
PARTS DESCRIPTION
1. Heating mode indication
2. Heating position switch
3. Heating lamps
BEFORE THE FIRST USE
Wall mounting:
• Determine a suitable location on a flat wall and hold on the top and sides at least 50 cm.
free space.
• According to figure 1, drill four holes with a 6mm. drill bit.
• Place the 4 plugs and screws into the holes and insert the heater over the screws.
3
4
1
2