Connecting To A Computer; User's Guide Addition For Windows - Compucessory 22082 Manuel D'instructions

CONNECTING TO A COMPUTER

Use the USB cable that comes with the calculator to connect it to your computer.
1. Connect the USB cable to your computer's USB port.
• Make sure you connect the cable directly to the computer's USB port. Proper
operation may be
impossible if you
connect the cable to a
daisy chained USB
device, USB port, etc.
2. Connect the other
end of the cable to the
calculator's USB port.
What to do next...
After you connect the calculator to your computer the first time, you need to
install the USB driver installer.
Follow the instructions displayed by the installer to install the driver. With
some computers, the USB installer should start up automatically when you
connect the calculator.
Important!
Never disconnect the USB cable while a calculator key operation is in
progress.
If you experience problems with data transfer between the calculator and
computer, try to disconnect and then reconnect the USB cable.

USER'S GUIDE ADDITION FOR WINDOWS

Note: • The original installation CD's may be required.
• It is recommended to install the device after Windows
loaded. Device may not work properly the first time if installed before
Windows is loaded.
®
• Operation is not guaranteed under Windows 98 / 98se / Me / 2000 /
XP updated from previous Windows
The following installation guide assumes the following system setup.
• Windows is located on the C: drive.
®
• Windows 98 is installed in a folder named Windows.
®
98 USERS
®
versions (Windows 95 etc.)
®
E2
is completely
®