Sandokan Mosquit All Mode D'emploi page 9

ATTENTION! CHECK THE PRESENCE OF DANGEROUS INSECTS INSIDE THE COM-
PARTMENT OF ATTRACTIVE
To clean the compartment of attractive use a damp sponge. Do not dip it in water.
- Insert the cover back, checking that the 4 pin of the cap match with the 4 holes of the
MOSQUIT ALL.
- Connect the device at the power mains to reactivate the trap.
Periodically replace the attractants, as stated in the indication of the manufacturer.
MOSQUIT ALL POSITIONING
To optimise its effectiveness, the device will have to be used in poor-lighted environ-
ments. Install MOSQUIT ALL in sparsely attended areas and, anyway, never remain near
the device for too long. In fact, mosquitos are generally more attracted by persons than
by the device, and could thus bite you before being trapped.
As well as indoor, MOSQUIT ALL can be also installed on balconies, gazebos and pa-
tios, provided that it is protected against rain and elements. Never expose it to water,
and do not plug it into a power outlet when wet.
MAINTENANCE AND CLEANING
Cleaning from insect residues:
- Before carrying out any maintenance operation, disconnect the device from power
mains.
- Release the base turning it counter clockwise and empty it (Fig. 5).
- Is possible clean the base of device and the filter with water. Dry thoroughly before
reuse.
- Lock the base back in place turning it clockwise (Fig. 7).
- Clean the device once every 15 days, or more often if required.
- Do not use insecticides to kill any insect still alive upon cleaning, as they could reduce
device effectiveness.
ATTENTION! If some dangerous alive insects are still present inside the base, let the de-
vice ON, and wait for them to die.
FILTER REPLACEMENT
After normal use, it may be necessary to replace the Extraction Filter, in case of wear or
when very dirty, after routine cleaning.
- Buy Sandokan Filter Kit Art. 7359;
- Before carrying out maintenance operations of any kind, the device must be discon-
nected from the power supply;
- Remove the lower section of the device by unscrewing it in an anticlockwise direction
(Fig. 5);
- Replace the old Extraction Filter with the new one, fitting it onto the top of the base
(Fig. 6);
- Replace the lower section by screwing it in a clockwise direction, and reactivate the
trap by connecting it to a power supply (Fig. 7).
In case of fan lock:
- Disconnect the device from power mains.
- Release the base turning it counter clockwise.