Mounting The Light Fixture; Testing; Care And Maintenance - Health Zenith 4635 Instructions D'installation Et Mode D'emploi

MOUNTING THE LIGHT FIXTURE

1. Make sure wire connectors and wires are inside the
junction box.
2. Slide the fixture assembly onto the mounting screws.
Tighten decorative nuts removed in step 1 of Light
Fixture Installation section securely against fixture base.
3. Caulk around fixture base with silicone weather sealant.
Caulking Around Fixture Base
1. Turn on the circuit breaker and light switch.
2. To test the light during daylight, cover the photocell
3. Uncover the photocell and your unit will operate
Decorative Nut
Mounting Screw
• To prolong the original appearance, clean the light fixture
with clear water and a soft, damp cloth only.
• Do not use paints, solvents, or other chemicals on this
Junction Box
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray the light fixture with a hose or power washer.
4

TESTING

with black tape and ensure the light works properly.
automatically – on at dusk, off at dawn.

CARE AND MAINTENANCE

Photocell
209890-01