Punkt MP 01 Mode D'emploi page 23

experienced radio/TV technician
for help.
Changes or modifications not
expressly approved by the party
responsible for compliance
could void the user's authority to
operate the equipment.
RF Exposure Information (SAR)
This device meets the government's
requirements for exposure to
radio waves. This device is designed
and manufactured not to exceed
the emission limits for exposure to
radio frequency (RF) energy set
by the Federal Communications
Commission of the U.S. Government.
The exposure standard for
wireless devices employs a unit
of measurement known as the
Specific Absorption Rate, or
SAR. The SAR limit set by the
FCC is 1.6 W/kg. *Tests for SAR
are conducted using standard
operating positions accepted
by the FCC with the phone
transmitting at its highest certified
power level in all tested frequency
bands. Although the SAR is
determined at the highest certified
power 20 level, the actual SAR
level of the phone while operating
can be well below the maximum
value. This is because the
phone is designed to operate
at multiple power levels so as
to use only the poser required
to reach the network. In
general, the closer you are to a
wireless base station antenna,
the lower the power output.
The highest SAR value for the
model phone as reported to
the FCC when tested for use at
the ear is 0.603W/kg and when
worn on the body, as described
in this user guide, is 0.495W/
kg (Body-worn measurements
differ among phone models,
depending upon available
enhancements and FCC
requirements.) While there
may be differences between the
SAR levels of various phones
and at various positions, they
all meet the government
requirement.
The FCC has granted an
Equipment Authorization
for this model phone with all
reported SAR levels evaluated
as in compliance with the FCC
RF exposure guidelines. SAR
information on this model
phone is on file with the FCC
and can be found under the
21