Oven Installation; Mounting Scale Plate; Mounting Plate - FULGOR MWOC324A1ABL Manuel D'installation

7.

OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED
WITHOUT REFERRING TO THE MOUNTING
INSTRUCTIONS FOUND ON WALL AND TOP
CABINET TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW
MOUNTING INFORMATION ON WALL AND TOP
CABINET TEMPLATES. THIS OVEN MUST BE
ATTACHED TO AT LEAST ONE WALL STUD. SEE
WALL CONSTRUCTION ON PAGE 4.
WHEN DONE WITH TEMPLATES, PROCEED TO
MOUNTING SCALE PLATE SECTION.

MOUNTING SCALE PLATE

Attach two Scale Plates 7 with tape (not included).
See Figure 6 and WALL TEMPLATE for locations.
Figure 6
7
Scale Plates

Mounting Plate

NOTE:
This Microwave Oven may not be built-in directly over
gas or electric ovens or cooktops. To reduce the risk of
fire or electrical shock, install at least 13 3/16" above
the countertop.
MOUNTING PLATE
1. Separate 4 Toggle Bolts 2, packed in the INSTAL-
LATION HARDWARE, from the Toggle Nuts.
2. Match 5/8" holes (not in studs), drilled through
WALL AND TOP CABINET TEMPLATE into wall to
corresponding holes on Mounting Plate.
3. Insert Toggle Bolts into matched openings on
Mounting Plate. Put Toggle Nuts on Toggle Bolts.
See Figure 7.
6
Models MWOC324A1ABL/WH/SS
Figure 7
Mounting Plate
4. Position the Mounting Plate with the Toggle Bolts
attached at the wall location and insert Toggle
Nuts and Bolts through the holes in the wall with
the Toggle Nuts closed. Figure 8. Use Wood
Screws 1 to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space
more than the thickness of the wall between the
Mounting Plate and the end of each of the Toggle
Nuts (in the closed position). If you do not leave
enough space, the Toggle Nut will not be able to
open on the other side of the wall. Also, once a
Toggle Nut opens, it cannot be withdrawn from
the hole; therefore make sure all of the Toggles
are in the correct position before insertion.
5. Align the Mounting Plate carefully and hold in posi-
tion while tightening Toggle Bolts. Pull Toggle Bolt
toward you and turn clockwise to tighten. Figure 9.
Figure 8
Space more than
wall thickness
Wall
Installation Manual
ENGLISH
Toggle
Bolt
Figure 9