Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
PERSONAL PRECAUTIONS
2.2
Remove personal metal items such as rings, bracelets, necklaces and watches when
working with a lead-acid battery. A lead-acid battery can produce a short-circuit current
high enough to weld a ring or the like to metal, causing a severe burn.
2.3
Be extra cautious, to reduce the risk of dropping a metal tool onto the battery. It might
spark or short-circuit the battery or other electrical part that may cause an explosion.
2.4
Do not permit the internal battery of the memory saver to freeze. Never charge a
frozen battery.
2.5
Consider having someone nearby to come to your aid when you work near a
lead-acid battery.
2.6
Have plenty of fresh water and soap nearby in case battery acid contacts your skin,
clothing or eyes.
2.7
Wear complete eye and body protection, including safety goggles and protective
clothing. Avoid touching your eyes while working near the battery.
2.8
If battery acid contacts your skin or clothing, immediately wash the area with soap and
water. If acid enters your eye, immediately flood the eye with cold running water for at
least 10 minutes and get medical attention right away.
2.9
If battery acid is swallowed accidentally, drink milk, water or egg whites. DO NOT induce
vomiting. Seek medical attention immediately.
3.
CHARGER AND AC POWER CORD CONNECTIONS
NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not allowed in
Canada. Use of an adapter plug in the United States is not recommended and should
not be used.
3.2
To reduce the risk of damage to the electric plug or cord, pull by the plug rather than the
cord when disconnecting the memory saver's charger.
4.
INSTALLATION INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the memory saver.
RISK OF EXPLOSIVE GASES. A SPARK NEAR
THE BATTERY MAY CAUSE A BATTERY
EXPLOSION. TO REDUCE THE RISK OF A
SPARK NEAR THE BATTERY:
2.1
the vicinity of a battery or engine.
RISK OF ELECTRIC SHOCK OR FIRE.
3.1
The memory saver's charger is for use on a nominal 120
volt circuit. The extension cord must be plugged into an outlet
that is properly installed and grounded in accordance with all
local codes and ordinances. The extension cord pins must fit
the receptacle (outlet). Do not use with an ungrounded system.
• 3 •
NEVER smoke or allow a spark or flame in
Publicité
Table des Matières
