Configuration Of The Account/Send E-Mail; Manual Configuration - Promelit ALESSITAB2 Mode D'emploi

2)
Select the Bluetooth device you want to connect to and press the
"Couple" button; Then enter the access password, if necessary.
When the Bluetooth connection is active, the
Bluetooth connection is shown in the upper right corner of the
screen, next to the icon of the
Wi-Fi icon
3)
You can change the name of your device by pressing the "Device
name" button and entering the desired name ("Device name" is
the identifier name of AlessiTab² when connected to another
Bluetooth-enabled device).
4)
If you want to make AlessiTab² detectable from another device by
using Bluetooth, select the gray box to the right next to the item
"Detectable". The tablet will then be detectable for 120 seconds.
Note that when the Tablet is connected via Bluetooth and it triggers the
display of a video, the AlessiTab ² screen will be darkened and the
images will be viewed only on the connected device.
To restore the use of the Tablet, press ALESSITAB² button and go
back.
8 E-mail: Configuration of the account/send e-mail
Select the "Mail" icon within the AlessiTab application. In the configu-
ration tab for a new account, insert your own e-mail address and the
associated access password, then press "Next" in the lower right
corner.
The Tablet will try to detect the settings of the account automatically.
In case this should not be possible, it is necessary to press the
"Manual Configuration" key in the lower left corner and to proceed with
the manual input of the various connection parameters requested, as
illustrated below in this section.
To input the underscore character (_), press the "?123" key on
the keypad and then "ALT".

MANUAL CONFIGURATION

For the incoming mail: choose either "POP3" (to be used with the
most common accounts such as @tin.it; @hotmail.com; @gmail.com;
etc.), "IMAP" or "Exchange".
In the case of a "POP3" server, input the access user name (generally
coincident with the e-mail address, check if necessary with your own
provider), the password (if not yet provided before), the address of the
POP3 server (e.g.: box.tin.it), the Port (default: 110), the type of
protection (if any), and then press "Next".
Once the connection attempt with the configured server is terminated,
input the requested data related to the server of the outgoing mail
(SMTP) in an analogue way than for the incoming mail, then press
"Next" to assign a name to the account just created.
Model's User Manual
).
NOTE:
icon of the
battery (and, if Active, the
10