Adler europe AD 7043 Mode D'emploi page 4

19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
27.Vacuuming dust and residues of construction causes immediate loss of warranty. The
vacuum cleaner is designed for domestic use only.
28. The device is outfitted with a rechargeable battery. Do not throw into a fire, puncture,
crush or damage the battery.
Device Description: (Handheld vacuum cleaner)
1. On/off button and speed control button 2. Battery indicator 3. Dust cup release button 4. Dust release button 5. Main body release
button 6. Electric tube 7. Brush release button 8. Powder brush 9. Battery 10.Dust cup 11. Adaptor connector
12. 2 in 1 crevice nozzle 13. Furniture tool 14. Adaptor 15. Docking station 16. Wall mounting
Using the device:
To turn the device On, press the On/Off button(1) once.
To increase speed press the On/Off button(1) again.
To turn off the device press the On/Off button a third time.
Charging:
To charge the device please plug the Adaptor (14) into the wall socket with the appropriate current.
Then insert the plug into the corresponding input on the Battery unit (9).
During the charging, the indicator lamp will start flashing.
Once the battery is full it will stop flashing.
Cleaning:
To clean the device please follow the below steps:
1. Press the dust cup release button (3) downwards with a firm press.
2. Once the cup is released from the main body press the Dust release button (4) over a garbage container to release the dust stored
inside.
3. On the upper side of the container, you will see 2 small handles. Pull-on them to release the plastic filter from the dust container.
4. Rinse the container with water and a nonabrasive cloth and leave to dry.
5. to release the sponge filter press on the handles with some force counterclockwise until you hear a click. Once you hear the Click pull
upwards to release the filter.
6. Rinse the filter with water and let it dry in the sun.
DO NOT INSERT OR ASSEMBLE WHILE WET OR DAMP. MAKE SURE ALL PARTS ARE DRY BEFORE ASSEMBLY.
DO NOT USE THE DEVICE WITHOUT FILTERS.
Assembly:
Please resemble the filters and cup by following the Cleaning instructions backward.
After that please align the cup with the motor unit.
At the bottom of the Dust container there is a groove, place the container base against it as shown on Picture 2.
Press firmly the upper part of the container against the motor unit until you hear a click sound.
Tube and Electro Brush.
To use the device it is advised that you use the tube and electro brush.
For that please insert the tube(7) into the main motor unit.