OfficeConnect 54 Mbps 11g Access Point Features
Power
LED
WLAN
LED
LAN
LED
Feature
Power Port
Ethernet Port
LEDs
Antenna Connector One RSMA antenna connector allows you to connect an antenna that
Reset Button
Observing Safety Precautions
This equipment must be installed in compliance with local and national building codes, regulatory
restrictions, and FCC rules. For the safety of people and equipment, only professional network
personnel should install the Access Point.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a minimum
body-to-antenna distance of 20 cm (8 in.) must be maintained when the Access Point is
operational.
WARNING: To avoid possible injury or damage to equipment, you must use power supply
equipment that is safety certified according to UL, CSA, IEC, or other applicable national or
international safety requirements for the country of use. All references to power supply in this
document refer to equipment meeting these requirements.
Description
The power port connects to the external power supply. Use only the 3Com
external power supply included in this package to power the Access Point.
The Ethernet port provides a 10/100BASE-TX Ethernet connection to a
3Com Wireless LAN switch. Use a suitable RJ45 cable to connect your
Access Point to a computer or other equipment that has an Ethernet port
(such as a hub or a switch). This port has an automatic MDI/MDIX feature,
which allows you to use either a straight-through or a crossover cable.
The LEDs indicate power and network activity. See "Checking the LED
Indicators" on page 5 for details.
operates in the 2.4 GHz band.
Push the reset button to restart the Access Point. To return the unit to
factory defaults, power off the unit, press and hold the Reset button, and
power on the unit again. Continue holding the Reset button for 15 seconds
and release. Cycle power again and AP will have the factory defaults.
2
Antenna Connector
Power Port
Ethernet Port
Reset Button