HDigit neo2go Manuel page 5

Connect with SmartPhone and other bluetooth devices.
1. Switch neo2go
ON , LED button shows blue, then blink between blue and red
while searching
2. Bluetooth will auto-search for the last previously paired units (for up to 10 seconds).
3. Once paired, the front LED button will continue to flash blue.
4. If Bluetooth can't discover prior paired units, it will search for new units to pair with.
5. Start your Bluetooth device and search for neo2go. The Bluetooth ID "neo2go" will be
detected in your Bluetooth manager. Once located, select to pair and connect with neo2go.
6. If Bluetooth can't pair successful (about 2 and half minutes), it will auto turn off.
Follow your device's instructions for Bluetooth Pairing. (Each is different!)
Initial pairing code is 0000.
Some take just seconds to pair, and some are less friendly and can take longer.
7. neo2go can pair with 2 bluetooth devices at the same time. : When one devices pairing, tap
the pairing(power) button till the indicator LED blink between blue & red, then your
second Bluetooth device can detect neo2go again ( just repeat step 5) .
Then, Enjoy the music by wireless.
Adjust the sound and volume
Adjust the +/- volume to your preferred volume level .The beep will remind at the
maximum level.