MioCARE L130 Serie Guide De Mise En Route page 13

en
Troubleshooting
Taking good care of your device will ensure trouble-free operation and reduce the risk of damage to
your device.
Power does not switch on
when using battery power.
Screen responds slowly.
Screen freezes.
Screen is hard to read.
Cannot establish a connection
with a computer.
Note:
•
If you encounter a problem you cannot solve, contact an authorised service centre for assistance.
•
Do not modify this device without authorization of the manufacturer.
• Never open the device. For safety reasons, only qualified service personnel should open the device.
12
Problem
The remaining battery power may be too low to run your device.
Charge the battery.
Make sure that your device is not running out of battery power.
If the problem still persists, reset your device.
Reset your device.
Make sure that the backlight of the display is set to a high-
enough brightness.
Solution
• Make sure that your device and your computer are both
switched on before trying to establish a connection.
• Make sure that the cable is securely plugged into the USB
port on your computer and on your device. Connect the
USB cable directly to your computer—do not run the cable
through a USB hub.
• Reset your device before connecting the cable. Always
disconnect your device before you restart your computer.