Troubleshooting - EAS ELECTRIC EMRH906X Guide D'utilisation

TROUBLE SHOOTING
Fault
The blades are blocked.
The capacitor is damaged.
Light on, but
The motor is damaged.
motor does
The internal wiring of motor is
cut off/ disconnected. An
not work
unpleasant smell may be
produced.
Apart from the above mentioned, check the following:
Both light and
Light damaged.
motor do not
Power cord loose.
work
Outlet and the air ventilation
Oil leakage
entrance are not tightly sealed.
The blade, if damaged, can
cause vibrating.
The motor is not tightly
Vibration
fastened.
The cooker hood is not tightly
fixed.
The distance between the
cooker hood and the cooker
Insufficient
top is too large.
suction
Too much ventilation from open
doors or windows.
The fixing screws are not
The
tight enough.
machine
The hanging screws are not
inclines
tight enough
Cause
12
Solution
Check the blades.
Replace capacitor.
Replace motor.
Replace motor.
Replace lights.
Connect the wires as the
electric diagram.
Take down the outlet and seal with
glue.
Replace the blade.
Fasten the motor tightly.
Fix the cooker hood tightly.
Readjust the distance.
Choose a new place to install the
appliance or close some doors/windows.
Tighten the fixing screw and make
it horizontal.
Tighten the hanging screw and
make it horizontal.
V.5