Lionelo Eva Manuel De L'utilisateur page 8

2. Base (fig. 4)
a.
The button should face outwards
b.
Insert the screw here
c.
Insert the long screw here to stabilise the base
3. Connecting the base to the upper part (fig. 5)
Using
Remove the mattress from the bed. Then, install the safety gate on the bed. Tighten
the securing screw (fig. 6, 7), and then place the mattress back.
In order to lower the protection, press the both lock buttons and fold the security
barrier down (fig. 8).
Additional protection
In order to apply additional protection, attach the belts.
There are two ways of installation of the protection belts:
1.
Hook the belt to the protection and use the screw to attach the end to the
bed board. Then tighten the belt using the adjustment feature (fig. 9, 10).
2.
Hook the belt to the protection and place the end between the mattress
and the bed. Then tighten the belt using the adjustment feature (fig. 9, 11).
Cleaning and washing
To wash the material covering, detach the tubes and pull them out of the base.
Take the material covering off. Wash it by hand, do not iron, do not machine dry.
The product has been tested and meets all the requirenments of the:
BS 7972:2001+A1:2009, EN71-3:2019
All the pictures in the manual have been submitted for illustrative purposes only and are
All the information in the manual is subject to change without prior notice.
EN
subject to change without prior notice.
‑ 8 ‑