Windsor Priza Serie Mode D'emploi page 5

Using the cleaner in any other way is
considered to be contrary to its intended
purpose. The manufacturer will not be
liable for any damages that occur as a
result of improper usage. In such cases
liability rests solely with the user.
Putting into operation for the first time
Affix the suction tube to the floor nozzle
and secure the connection by
tightening the union nut in an
anticlockwise direction.
Important note: Make sure that the spray
tube lying inside the tube is properly
connected, otherwise this will lead to a
malfunctioning of the unit.
If required, push the handle on to the
suction tube and screw it tight at the
required position using the enclosed
allen key.
Affix the elbow to the suction tube and
secure the connection by tightening the
union nut in an anticlockwise direction.
Put the suction hose of the spray-
suction hose on to the connector on the
unit (Fig. 1a). Press the coupling of the
spray hose on to the connector. Make
sure they engage properly (Fig. 1b).
Place the spray-suction hose firmly on
the grip section (Fig. 2a) and place the
coupling of the spray hose on the
connector of the grip section. Make
sure they engage properly
(Fig. 2b).
Put on the suction tube and floor
nozzle and make the connection
secure by turning the union nut by
hand in an anti-clockwise direction.
The hand nozzle for cleaning
upholstery ( optional accessory ) is
placed directly on the spray-suction
hose.
If required, the step nozzle (special
accessory) or the metal floor nozzle
can be used.
Putting into practical use
Mix cleaning agent (RM) and clean
water thoroughly in a clean container
in accordance with the instructions (Fig.
3).
Fill fresh-water tank up to the "Max."
line, but not above this (Fig 4).
Note: Warm water increases cleaning
efficiency (max. 122 °F/+50 °C).
Place dirty-water container in the
housing and put the lid on.
Put power plug in the socket.
Switch on unit with the "Suction" and
"Spray" buttons (Fig. 5).
To spray - press lever on grip section
and keep it pressed. By doing so the
cleaning solution is sprayed on and in
the same process is vacuumed up (Fig.
6).
Go over the surface to be cleaned in
overlapping strips with the relevant
nozzle, put on the nozzle and work
backwards
(Fig. 6).
When the dirty-water reservoir is full or
the fresh-water tank is empty, it is
essential to turn the unit off with the
"Suction" and "Spray" buttons.
Remove cover, take out dirty-water
reservoir and empty it (Figs 7, 8).
Repeat working steps if necessary.
Cleaning carpets and upholstery
For cleaning carpets, apply the 9.1 in
(230 mm) floor nozzle.
For cleaning upholstery, stair carpets,
wall hangings or the inside of the car,
apply the 4.3 in (110 mm) hand nozzle
( optional accessory ).
When cleaning upholstery, the amount
of cleaning solution must be reduced
for delicate fabrics and the surface
wetted at a distance of approx. 7.9 in
(200 mm).
5
English