Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- To improve the unit performance, we recommend charging the battery twice a year, by letting the motor run
until it stops completely. Then fully recharge it for 8 hours.
HOW TO CONNECT CUTTING ATTACHMENTS
Cutting attachments such as hair-clipper (1), beard trimmer (10), can be connected and disconnected to the
unit in the same way. Follow the below steps:
1. To connect the attachment to the unit, press the accessory against the unit until it locks.
2. To disconnect the cutting accessory, pull the attachment from the blade side, and detouch it.
TIPS FOR CUTTING
- Make sure that the device is fully charged before starting the cutting process.
- Use only on clean and dry hair and never use it on wet hair.
- Make sure that the head of the person whose hair you want to cut is at the same level as
your shoulders; in this way, each cutting zone will be clearly visible.
- Cut hair in the direction of growth (see Fig. 5).
- Install the cutting attachment as described in the previous paragraph.
OPERATING THE UNIT
1.
HAIR CLIPPER
- After having installed the attachment (1) to the unit, connect one of the 4 hair clipper combs (6-7-8-9) to the
attachment (1) and on both sides until it clicks in position.
- Without the comb the cutting height can be set to 3 levels (0.8 - 1.1 - 1.4mm) using the selector (2) on the
upper part of the appliance.
- Choose the comb depending on the desired level, as indicated in the below table:
Without comb
Note: when you are trimming for the first time, you may want to start with the longer length to familiarize
yourself with the appliance.
- Turn on the unit by moving the operation switch (3). Move device slowly in the direction of hair growth:
since hair does not grow in the same direction, it is recommended to move the clipper in various directions.
- For best results, make sure that the flat part of the comb is always in contact with the scalp.
- Make several passes over the head to ensure you cut all the hair you need to.
- Regularly remove remaining hair on the comb. If you need, switch off the appliance to remove the comb
and clean the cutting blade.
CONTOURING WITHOUT THE COMB
The device can also be used without the cutting comb, to cut very short hair (0.8-1.4 mm long), to contour the
neckline, the sideburns and the area near the ears.
WARNING: Be careful when using device without the comb since the blades are very sharp.
- Extract the cutting comb (6-7-8-9).
- Before finishing the outline on the neck or around the sideburns, fade hair above the ear.
- Tilt device so that only one edge of the blade touches the hair to finish the nuances around the ear.
- To contour sideburns or neckline, turn the appliance and make downward strokes, always following the
natural hairline.
2.
BEARD TRIMMER
- Attach the beard trimmer (10) to the unit and insert the beard trimmer comb (44) by sliding it into the
guides until it snaps in position (see Fig. 13).
Comb
1
2
3
4
Hair length (after clipping)
0.8 - 1.1 - 1.4 mm
3 mm
6 mm
9 mm
12 mm
12
Publicité
Table des Matières
