Shure UA101 Mode D'emploi page 3

ALTERNATE WIRING CONFIGURATIONS
The UA101 switch can be wired four different ways, depending on which function
you wish to use. See Figure 1. To change switch wiring, proceed as follows:
1. Remove the three Phillips screws from the back of the switch.
2. Lift off the rear cover to expose the wire terminals. Remove the wires from the ter-
minals; then reconfigure and rewire the switch as desired. See Figure 1.
SLEEVE
UA101 CABLE
RING
TIP
UA101 TERMINAL
RED (TIP)
Push to Mute (Audio Mute/Unmute Only)*
*Original factory configuration
UA101 TERMINAL
WHITE (RING)
Push to Talk (Audio and RF Mute/Unmute)
UA101 TERMINAL
WHITE (RING)
Push to Mute (Audio and RF Mute/Unmute)
UA101 TERMINAL
RED (TIP)
Push to Talk (Audio Mute/Unmute Only)
SWITCH WIRING OPTIONS
FIGURE 1
SHIELD (GROUND)
RING (WHITE)
TIP (RED)
GROUND (SLEEVE)
WHITE (RING)
RED (TIP)
GROUND (SLEEVE)
GROUND (SLEEVE)
RED (TIP)
WHITE (RING)
GROUND (SLEEVE)
3