Metalux ADF140683 Instructions D'installation

ADF140683
Installation Instructions – SSF Long Connector
Instructions d'installation - Connecteur long SSF
Instrucciones de instalación del conector largo SSF
IMPORTANT: Read carefully before installing fixture. Retain
for future reference.
warning
risk of fire, electrical shock, cuts and or other casualty
hazards. This product must be installed in accordance
with the applicable installation code by a qualified
electrician or a person familiar with the construction
and operation of the product and the hazards involved.
Cooper Lighting Solutions assumes no responsibility
for claims brought about by improper or careless
installation or handling of this product.
aTTEnTiOn
receiving Department: note actual fixture description
of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly
with carrier. Claims for concealed damage must be
filed within 15 days of delivery. all damaged material,
complete with original packing must be retained.
CauTiOn
Edges May Cut. Handle with care.
INSTALLATION
1. Remove end plates and flip socket tracks in place.
2. Insert connector into row aligner lances of channel.
Slide connector until it's fully engaged.
4
2
3
1
CauTiOn
Risk of Burn. Disconnect power and allow fixture to cool
before changing bulb or handling fixture.
warning
risk of Fire and Electric Shock. if not qualified, consult
an electrician.
nOTiCE
Green ground screw provided in proper location. Do not
relocate.
nOTiCE
Lamps contain mercury, dispose according to local, state,
or federal laws.
nOTiCE
If supply wires are located within 3 inches of ballast, use
wire rated for at least 90°C (194°F).
3. Repeat Step 2 with next channel in row.
4. Fasten connector using the hardware provided.
Install wire holder provided if
running a harness along
Brand Logo
reversed out of
black
INS # INS #
View of connector from
inside of channel.