FONESTAR FA-8060 Mode D'emploi page 3

HEADPHONE RECEIVER (mod. FA-8060R)
1.- LED power indicator. Remains lit if the headphones are in use.
ON/OFF: headphone on/off switch.
2.-
3.- Battery compartment, uses two alkaline or rechargeable 1.5 V batteries type LR03-AAA. When inserting
the batteries, make sure that the polarity is correct.
4.- LED signal reception indicator: it lights up when a signal is received coming from the transmitter.
TUNE: press this button to automatically tune the transmission channel.
5.-
VOL: .volume control. Increases or decreases the audio level.
6.-
7.- Audio input, 3.5 mm stereo jack connector to use as wired headphone.
CONNECTION
- Connect the audio source stereo audio output signal to the transmitter's AUDIO INPUT with the
corresponding cable.
- Power the transmitter with the mains adapter provided.
- Insert two alkaline or rechargeable 1.5 V batteries type LR03-AAA in the Hi-Fi stereo headphone receiver,
making sure that the polarity is correct.
INSTRUCTIONS FOR USE
1.- Make the transmitter connections according to the Connection section.
2.- The transmitter will switch on automatically when the audio signal is received, activating the LED power
indicator
Note: if it does not receive an audio signal, the transmitter will automatically switch itself off after 3
minutes
3.- Switch on the headphone receiver by placing the power switch in the ON position. The headphone LED
power indicator will light up.
4.- Press the TUNE button to automatically tune the transmission channel.
5.- In the event that no clear or strong signal is received or a signal with interference is received, change the
transmission channel with the transmitter's CH1/CH2/CH3 switch. Then repeat step 4 to tune the new
transmission channel.
6.- Adjust the volume of the signal received until an adecuate level is reached using the headphone VOL
control.
- 3 -
EN