RECA R200 Mode D'emploi page 4

Operating instructions
RECA workshop lamp R200
SAFETY INSTRUCTIONS
- Read the operating instructions carefully before using and observe the safety instructions!
- Do not use the device if there is damage to the housing, plug or cable. Consult your local
authorised specialist!
- The device must only be operated in closed, dry rooms!
- Carry out cleaning tasks only when the mains plug is removed from the mains power!
- Do not open the device! Repair work and replacing the rechargeable battery pack may only
be carried out by electricians.
- Keep away from children! Children should be supervised in order to ensure that they do not
play with the device!
- This device is not to be used by persons (including children) who have restricted physical,
sensory or mental capabilities or who do not have adequate experience and knowledge in
handling this device. Such persons must be instructed beforehand by a supervisory person
who is responsible for their safety or must be supervised during the use of the device!
- Failure to observe the safety instructions can result in dangerous injuries to persons or
damage to the device!
SCOPE OF DELIVERY
- Workshop lamp R200
- USB power supply 5V/500mA
- USB/Micro-USB charging cable 150cm
- Manual
FUNCTIONAL OVERVIEW
- Professional workshop lamp with the latest SMD LED technology
- Robust plastic housing with rubber-coated grip
- Can be swivelled through 340°, lamp grip can be locked in twelve positions for flexible
direction of the light
- Fastening magnet on the bottom of the of the grip
- Fold-out hook on the top of the housing can be swivelled through 360°
- Integrated belt clip on the rear of the housing
- Light with two light functions (100% / 50% light power)
- Permanently installed Li-ion rechargeable battery pack (3.7V / 1500mAh)
- Charge monitoring via coloured LED on the rear side of the lamp
TECHNICAL DATA
Integrated illuminants: 5x SMD LEDs, Nominal power 3.25W
Lighting intensity:
Luminous flux:
Battery life:
Input voltage for the
external mains adapter: 100-240V AC / 50-60Hz
Charge time:
USE
The on/off switch for the workshop light can be found on the top of the housing:
- Press 1x: The workshop lamp will be switched on in 100% light mode.
- Press 2x: The workshop lamp illuminates at the 50% setting.
- Press 3x: The lamp is switched off.
545 Lux at 0,5m distance
330 Lumen
ca. 3h (100% light power), ca. 9.5h (50% light power)
ca. 4h