Dsp Setting - ASA Electronics ASABG6 Manuel D'utilisateur

DSP SETTING

Mode Switch
Remove the side panel door using a #2 Phillips screwdriver. Determine best DSP setting based on the table below. If the
chosen speaker model(s) is not shown in the table, use "Memory 1". "Memory 1" still uses the DSP for signal processing, but
the EQ and gain is not optimized for any particular speaker. When the power amplifier is turned OFF, rotate the mode select
switch (1) to desired memory location. Once mode is selected make sure to reinstall the side panel door before further
operation.
Table 1: Mode Switch Table
Mode Switch Speakers
Memory 0 Reserved
Memory 1 Flat (other)
Memory 2 4 x DB522
1 x DB842SVC
Memory 3 6 x DB652
Memory 4 4 x DB652
1 x DB842SVC
Mode Switch Speaker
Memory 5 6 x UMS66
Memory 6 4 x UMS66
1 x UMS108
Memory 7 OEM 1
Memory 8 4 X JXHD60HPC
Memory 9 OEM 2
5
ASABG6