Publicité
Les langues disponibles
Les langues disponibles
UC120-LED WIRING COMPARTMENT
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
INSTALLATION
•
Remove the connector cap on the side of the wiring compartment.
•
Open the wiring compartment cover by pressing underneath the side tabs
•
Install a 3/8" cable clamp any of the three knockouts.
•
Pass a NMD90 14AWG through the cable clamp.
Tighten cable clamp screws to 2.26N•M (20lbs•in).
•
Make appropriate connections as per wiring diagram.
•
Close the wiring compartment cover.
•
Mount wiring compartment with 4x screws to desired location under
the cabinets.
•
Attach the undercabinet light with interconnect cable
(sold separately).
WIRING
•
Check that the line voltage is correct.
•
Connect fixture GROUND (green) w ire to power supply GROUND (green) wire.
•
Connect fixture WHITE wire to power supply NEUTRAL wire.
•
Connect fixture BLACK wire to power supply LINE wire.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
CONNECTOR CAP
2020-03-26
FOLLOW
, and
these instructions
INSERT SUPPLY WIRE
SIDE TABS
Page 1 of 1
Publicité
