Operation - Caso Germany IceMaster Pro Mode D'emploi

15.2 Operation

Caso IceMaster Pro
Please note
Please wait for one hour before you switch on the ice maker.
You will find that the cooling liquid settles out in this time.
• Open the cover of the ice maker and remove the ice
basket.
• Fill water into the water reservoir and keep water level
below the water level mark.
• Press the "Power" button to begin the ice making cycle.
• Select the ice cube size by pressing the "Select" button. If
the room temperature is lower than 15°C, it is
recommended to select small ice cube in order to avoid
ice sticking together.
• Depending on selection of ice cube size and room
temperature, the ice making cycle lasts approx. 6 to 13
minutes.
• If water pump can't inject water, the ice maker will stop
automatically. The "Add Water" indicator will be on. Press
the "Power" button and fill in water. Then press the
"Power" button again. Allow the ice maker at least 3
minutes to settle before restarting.
• The ice maker stops working when the ice basket is full. In
this case the "Ice" indicator will be on.
• Drain all the water, if unit isn't used. Always store the unit
without water in the water reservoir.
Please note
Change water in the water reservoir every 24 hours to avoid
pathogenic organisms.
39