AGP G125 Instructions De Sécurité page 8

serious injury.
WARNING: Indicates a potentially hazardous situation which if not avoided will result in death or serious
injury.
BEFORE USING THIS TOOL
WARNING: Some dust created by the power sanding, sawing, grinding, drilling and other construction
activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-bases paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment such as
dust masks specially designed to filter out microscopic particles.
UNPACKING
Remove the tool and all loose parts from the carton. Place all parts on a secure, stationary work surface and
look the machine over carefully.
LIST OF PARTS
List of Contents
Basic Assembly....................................
Operator's Manual.............................
Lock Nut Wrench................................
Face Spanner Wrench .......................
Flanges...................................................
RECOMMENDED ACCESSORIES
This machine may only be used with diamond cup wheels of its model specific diameter (see machine
nameplate) with 22.23mm (7/8") arbor hole or with M14 female thread.All other uses are prohibited. Bonded
abrasive accessories are not allowed to be used with this machine.
BASIC OPERATION
NOTE: Make sure that the power circuit voltage is the same as that shown on the specification plate of
the machine and that switch is "OFF" before connecting the tool to the power circuit.
GB
1
1
1
1
2
8