Stand Installation - INOVU MB27 Guide D'utilisation

STAND INSTALLATION

1. Unpack the carton, remove the foam and lay the monitor flat on the tabletop.
Keep the foam under the monitor while installing the stand.
Remove the upper foam cover and put it aside, take out the monitor film bag and put
2.
the monitor in the lower foam cover. Take out the stand, install it on the machine
shaft of the monitor and tighten them with 2x screws Km4*10.
1. Take out the base, assemble it with the stand and fasten with 2x screws Km4*10.
2x screws
Km4*10