D-Link DCS-850L Guide D'installation Rapide page 7

Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
Warning: Indoor use only. Do not mount the camera in a location
where it may be in contact with water as it may damage the product
and/or cause injury.
• Place the mounting bracket where you want to
position the camera and use a pencil to mark the
points where you will drill the holes.
• Use a 6mm drill bit to drill the two holes where you
marked. The holes should be 25mm deep (about 1 in
deep). Insert the screws into the holes.
Note: If the wall is made out of concrete, before inserting
the screws, insert the provided plastic anchors to support
the screws.
• If you prefer, you can conceal the cable behind the
mounting bracket. Run the cable through the back
of the mounting bracket, securing it with the built-in
guides. Make sure you leave enough cable protruding
to allow you to connect it to the camera.
• Fasten the mounting bracket to the wall using the
screws provided.
Do not overtighten the screws as this may damage the bracket.
• Using the supplied thumbscrew, fasten the camera
to the mounting bracket. Connect the power cable to
the camera.
• Adjust the angle of the arm on the mounting bracket
as desired. Tighten the thumbscrew to lock the arm
into place.
Mount the Camera
7
1
2
3
4
5
6