Overmax Multipic 5.1 Manuel De L'utilisateur page 20

Problem
3. No image
EN
4. Automatic shut-down
The pictures are for reference only. The real design of the products may differ from
the pictures presented.
Possible causes
No input signal
Input cable is not connected
In PC mode the PC output
frequency is not 50-60 Hz. Make
sure the PC output is connected to
projector
If you use laptop, check if output
signal is HDMI1 or HDMI2
Projector ventilation is blocked
Voltage is not stable
Projector is overheated, check if
fan (13) is not damaged