Cleaning And Maintenance - BEGA Cone Heater CHu Mode D'emploi

Caution!: Bear in mind that after switching off the main switch the cone is still hot and will need time
to cool down. Make sure the cone cannot be touched.
Note: The workpiece is heated from the bottom to the top. It is recommended to turn around wider /
higher workpieces during the heating process once in order to ensure even heating throughout the
workpiece and to speed up heating times.
WARNING!
If in doubt about the correct functioning of the heater, stop and prevent use.
Contact your supplier.

8. Cleaning and maintenance


Store in a dry place, free from frost and damp.

Clean with a dry cloth. Never clean using water.

Contact your supplier if in doubt about the correct functioning of the device.

Repairs must be carried out by the manufacturer or a specialist approved by the manufacturer.
WARNING!
 Carrying out maintenance and following the instructions is important. Neglect can cause
the machine to break down and lead to possible personal injury.
© Bega International BV, September 2016 9