Publicité
Les langues disponibles
Les langues disponibles
8. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the conditions
and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially for
any matters that are not referred in the above
IV- GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage.
4.2- Legs assembly
Place the legs against main body and fix them with the provided screws.
Check that all legs are properly and securely assembled.
Tighten screws, if necessary.
Note: regularly check the screws and tighten when necessary.
4.3- Connecting the hose
The hose (not supplied) must conform to the relevant standards of the country of use, and the its length
cannot exceed 1.5m maximum to connect the unit to the gas supply source.
Connect one end of the hose to the nipple (7) of the valve manifold.
Connect the other end of the hose to the gas supply (eg bottle) using 28Mbar regulators for Butane gas and
37Mbar for Propane gas.
Notes:
Observe the use-by date on the hose.
The hose must not be in contact with the hot surfaces of the equipment.
The hose must not be subjected to torsional or tensile forces.
Use hose clamps (not supplied) suitable for hose connection.
4.4- Ignition of the burners
Open main gas supply valve.
Open the middle control valve (8) counterclockwise to release and light the inner burner with a match or a
lighter.
When the inner burner is alighted, then open the other control valves and light the other burners.
Adjust the flame to the cooking vessel diameter.
To turn the burner off, rotate control valve (8) clockwise until the OFF position.
Remark:
The middle valve controls the small central burner.
The left valve controls the left side of the big burner.
The right valve controls the right side of the big burner.
Page 12 / 13
Publicité
