Installation; Appliance Installation; Water Connection - Steibel Eltron ESH 10 U-N Trend Utilisation Et Installation

INSTALLATION

Installation
8.1.2 ESH 10 O-N Trend - oversink installation
Note
The ESH 10 O-N Trend is designed exclusively for oversink
installation. The water connections of the appliance point
downwards.
Material losses
!
Connecting hose length (from tap to appliance) may not
exceed 1 m.
For connecting hoses > 1 m:
f Install a tube aerator attachment in the overflow f
line.
9. Installation
9.1

Appliance installation

f Mark out the holes for drilling with the installation template f
supplied.
f Drill the holes and insert suitable rawl plugs. f
f Secure the wall mounting bracket using suitable screws. f
f Hang the appliance on the wall mounting bracket. f
Note
Surplus cable can be stored in the cable compartment.
16 | ESH 10 U-N Trend | ESH 10 O-N Trend
9.2

Water connection

Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
Material losses
!
The appliance may develop a leak and cease functioning.
f Never subject the appliance to water pressure. f
f Never interchange the water connections. f
f Set the flow rate (see tap instructions). Observe the f
maximum permissible flow rate with a fully opened
tap (see chapter "Installation / Specification / Data
table").
Material losses
!
When tightening the fittings, counterhold with a suitable
spanner.
ESH 10 U-N Trend
Match up the colour coding on the tap water connections and the
appliance:
- R.h. side blue = "Cold water inlet"
- L.h. side red = "DHW outlet"
f Secure the water connections from the tap to the appliance. f
Note
Ensure that the water connections are not kinked during
installation. Prevent any tensioning during installation.
ESH 10 O-N Trend
f Secure the water connections from the tap to the appliance. f
www.stiebel-eltron.com