Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Quick Start
Easy step by step instructions for getting a quick start with the unit - it will run under the fac-
tory default if you do not change any parameter:
•
Put the main power switch which is allocated in the bottom of out-side cabinet to ON
•
After PW is ON, system will be ready for setup. Press CAM-PW to switch on the camera
section.
•
Set date and time for the camera and choose either picture or video mode.(See the para-
graph below for "Date and time Setting"; Still Picture / Video Mode)
•
Set other parameters of scouting and exit the setting mode after finished. (See more pa-
ragraphs about the setting for motion sensor below)
•
Hang unit on a steady tree around 1 meter height with the attached belt that almost point
to the area which you wish to monitor.
•
Put the main PW switch to TEST and turn the sensor gain to max. (Clock-wise). After the
SELF-TEST light goes OFF after 1 minute, try to walk in front of motion sensor in order to
22
Publicité
Table des Matières
