Publicité
eNet
Capteur d'énergie radiofréquence, 4 voies, modulaire
Rel. threshold value, effective
output
Abs. threshold value, effective
output
Suppression length, effective
output
Averaging length
Information window
During channel selection in the Information window, the following values are displayed.
Display value
Measuring status:
value is real/
out of service
Measuring status:
no fault/
value is corrupted due to failure
Measuring status:
in commission
Measuring status:
time synchronisation active
Measuring status:
Acknowledged
Measuring status:
no alarm
Voltage
82582003
J:0082582003
1 ... 50 %
Basic setting: 10 %
0 ... 2000 W
Basic setting: 1 W
0 ms ... 300 s
Basic setting: 0 ms
0.2 ... 300 s
Basic setting: 1 s
Explanations
value is real: Device being operated
out of service: Device error
no fault: Measurement active
value is corrupted due to failure: The sensor is
not supplying valid measured values.
Not used.
Not used.
Not used.
Not used.
Displays the current voltage value.
7/8
The transmission of consump
tion data can be coupled to
the change in effective output.
The basis is always the most
recently transmitted effective
output value. If the percentage
change entered here is excee
ded, then all the measured va
lues are resent.
A lower threshold value of the
effective output can be ente
red here, to avoid frequent
transmission in the lower po
wer range. Eventcontrolled
transmission is only active
above this threshold value.
Triggers for eventcontrolled
transmission are often switch
on and switchoff operations.
In order to avoid incorrect
measured values due to
switchon peaks, this parame
ter can be used to enter a sup
pression period. The measu
red values are only transmit
ted if the effective output is still
above or below the relative
threshold value after the set
time.
In the case of effective output,
it is not the current value
which is transmitted, as with
other measured values, but
the average value. It is pos
sible to set the period for ave
rage value formation here.
14.03.2014
Publicité
