Publicité
UK Regulatory Compliance
Compliance with the Regulations 2017（SI 2017/2016）
Honglink Wireless Solutions Co., Ltd. declares that this device IG830 is in compliance with the essential requirements
and other relevant provisions of the UK Radio Equipment Regulations 2017(SI2017/2016).
RF Exposure Information (SAR)
This device is designed not to exceed the emission limits for exposure to radio waves (radio frequency
electromagnetic fields) adopted by Council Recommendation 1999/519/EC, ICNIRP Guidelines, and UK Radio
Equipment Regulations 2017 (SI 2017/1206). The radio wave exposure guidelines use a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit is 2W/kg. Testing for SAR are conducted using standard operating
positions at 5 mm distance with the device transmitting at its highest certified power level in all tested frequency
bands. The highest SAR values for this device is 1.53 W/Kg.
Frequency Bands and Power
The maximum radio-frequency power transmitted in the frequency bands in which the radio equipment operates: The
maximum power for all bands is less than the highest limit value specified in the related Harmonized Standard.
GSM 900: 35 dBm
GSM 1800: 32 dBm
UMTS Band 1: 25 dBm
UMTS Band 8: 25 dBm
LTE Band 1/3/7/8/20/28/38/40: 25 dBm
FCC Regulatory Compliance
FCC regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult an authorized dealer or service representative for help.
Honglink Wireless Solutions Co., Ltd. is not responsible for any radio or television interference caused by using
other than recommended cables and connectors or by unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
RF Exposure Information (SAR)
This device is designed not to exceed the emission limits for exposure to radio waves (radio frequency
electromagnetic fields) adopted by the Federal Communications Commission (FCC)
The radio wave exposure guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The
SAR limit is 1.6W/kg. Testing for SAR are conducted using standard operating positions at 5 mm distance with the
device transmitting at its highest certified power level in all tested frequency bands. The highest SAR values under the
FCC guidelines for this device is 1.18 W/Kg.
67
Publicité
