Rollei 22642 Notice D'utilisation page 8

Product Overview
8
Pitching
Status
Indicator Light
USB Port
Part of the delivery
• 18650 Rechargeable Battery
• 1x Micro USB Cable
• 1x Counter Weight
• 1x Transport Bag
• 1x User Manual
1. Installation
Download and install the Rollei App called "Rollei Smart Gimbal"
onto your smartphone .
The App supports iOS 8 .0 and Android 4 .4 or above .
2. Battery Installation
The battery needs to be fully charged before the device is used for
the first time . The charging time is about 2 .5 hours when it is directly
charged by a power outlet (therefore an adapter is needed which is
not part of the delivery) .
The battery needs to be inserted into the handle of the gimbal . There-
fore, please unscrew the lowest part of the handle . Then insert the
battery into the handle (the minus polarity shows in the direction of
the small part of the handle) . Afterwards the small part can be screwed
onto the handle again .
ENGLISH
Rolling
Panning
360°
Function Button &
ON/OFF (Status
Indicator Light)
1/4 inch screw
thread
Charging: Insert the USB cable into the USB port
of the gimbal and plug the other side into a charging
port of a power source .
Roll Axis
Pitch Axis
3. Mount the Smartphone
Pan Axis
Please make sure that the gimbal is turned off . Insert the smartphone .
Therefore put it with one side into the smartphone holder, push
Joystick
the upper part from the holder to enlarge the holder and press the
smartphone inside . Make sure that the smartphone is well inserted
and that it cannot fall out .
NOTE: The home button of the smartphone should be at the side near
to the pitch motor . Please ensure that the smartphone is fixed tightly
in order to avoid shaking of the gimbal .
4. Balancing the Smartphone
If the gimbal is turned on and the smartphone is balanced / levelled
correctly and will be held by the gimbal without making any sounds
or any shakes, the smartphone is positioned correctly .
Fig. 1 Without the counter weight: suitable for iPho-
ne 6/6s/7 and similar Android smartphones
1
Fig. 2 If the smartphone tilts to the left, you need to
add the counter weight . Therefore unscrew the cap
at the pitch angle and put the counterweight on and
screw the cap on again (such as iPhone 6 plus / 6s
plus /7 plus and similar Android smartphones) .
2
Fig. 3 If the smartphone tilts to the right, you need to
move the phone a bit more to the left side up to the
point where the gimbal can balance the smartphone .
(Such as iPhone 5 / 5s and similar Android smart-
3 phones) .