Information Button; Start/Pause Button; Fill Set Button; Settings Button - Nutricia flocare Infinity III Mode D'emploi

5.1.3

Information button

The INFORMATION [ ] button (i-button) provides help and additional information about the actual pump state
at any given time.
Examples:
- In a running mode, the information button provides information about the status of the therapy.
- In pause mode, the information button will give recommendations how to program a therapy depending
on your selected therapy.
In an alarm state, the information button [ ] provides recommendations on how to solve the indicated
-
alarm by providing potential solutions.
5.1.4

Start/pause button

The START/PAUSE [ ]button starts or pauses a programmed therapy.
5.1.5

Fill set button

The FILL SET button primes the Flocare Infinity giving set to ensure that air within the system has been purged.
5.1.6

Settings button

The SETTINGS button provides access to the pump settings.
See chapter 7.4 'Settings menu' for full button functionality
5.1.7

Therapy button

With the THERAPY [ ] button, you can select your desired therapy.
See also chapter 7.5 'Programming the pump', 7.4.1 'Define therapy list' and 7.5.5 'Program a PERSONALISED
THERAPY'.
5.1.8

On/Off button

The ON/OFF button switches the pump ON and OFF.
Note: to avoid unintended button presses, the ON/OFF button needs to be pressed for 2 seconds for both
switching the pump ON or OFF.
5.1.9

Soft buttons

The soft buttons relate to the function on the screen which has an action indicated by the "<, >, !,",#,$,+,-"
symbol.
Note: the SOFT buttons are only active when accompanied with the above-mentioned symbols, if no symbol
appears, the button is inactive.
5.2

PUMP STATUS INDICATOR

The pump status indicator provides a visual indication of the actual pump status.
- A green light indicates that the pump is in delivery mode and working normally.
- An orange light indicates that the pump is in pause mode and waits for user input.
- A red light indicates an alarm state; immediate action from the user is required.
5.3

DISPLAY

The Flocare Infinity III will perform a display test during each pump start. Carefully check for any sections or pixels
that do not appear during the display test.
Caution: In case of any missing sections or pixels, the pump should not be used and to be send to an authorised
service centre for inspection.
- 9 -