Prem-I-Air EH0468 Mode D'emploi page 5

"SPEED" Button: Set the fan speed using the fan speed control.
In all modes except dehumidifying mode. The fan speed can be low, medium or
high. The fan speed is indicated by the speed of the segments on the windmill
symbol on the LED display.
TEMP+ and TEMP˜ buttons:
Use the + and ˜ buttons to select the desired room temperature. The temperature
can be set to any temperature from 16 °C to 31 °C. Selecting a lower
temperature whilst heating, or a higher temperature whilst cooling will reduce
power consumption.
SWING button: Press the "SWING" button to turn the oscillation of the louvres
on or off.
Before putting the appliance into storage, empty all water from the drain, and run
the appliance on "fan only" mode for a few hours to dry the inside thoroughly.
Clean the filter, unplug the mains cable, and store the appliance in its original box
in an upright position. Remove the battery from the remote control.
If the "WATER FULL" indicator lights, the condensate
water tank is full. This should only happen very rarely, as
most of the water collected is evaporated and sent down
the exhaust air tube.
To empty the water, switch the unit off by pressing the
ON/OFF button, wait for three minutes, and then
disconnect from the mains supply. Place a drainage pan
underneath the drain outlet plug (an the bottom of the unit,
at the back in the centre). Withdraw the bung, and allow
the water to drain into the drainage pan. Replace the bung,
and reconnect the unit to the mains supply.
The water should be disposed of down a drain.
END OF SEASON STORAGE.
Page 5
To avoid the need to empty the water,
a permanent drain tube may be fitted
as shown: use a piece of 18mm
diameter tube (not supplied) and run
the pipe to a drain, making sure that it
runs downhill all the way.
Unplug the EH0468 from the mains
when not in use.