Publicité
Liens rapides
Publicité
Manuels Connexes pour BE SP-550SD
Sommaire des Matières pour BE SP-550SD
- Page 1 SUBMERSIBLE PUMP User Manual...
- Page 2 Using the Operator’s manual The operating manual is an important part of your Submersible Pump. It should be read thoroughly before initial use, and referred to often to make sure adequate safety and service concerns are being addressed. Reading the owner’s manual thoroughly will help avoid any personal injury or damage to your pump.
- Page 3 INTRODUCTION PRODUCT IDENTIFICATION Record Identification Numbers Submersible Pump If you need to contact an Authorized Dealer or Customer Service line (1-866-850-6662) for information on servicing, always provide the product model and identification numbers. You will need to locate the model and serial number for the pump and record the information in the places provided below.
- Page 4 1¼” (32mm) hoses are detached with a knife from the universal fitting, illustration E.) Liquids which can be handled by the Submersible Pump are the following; clean or slightly contaminated water (max. particle size 0.2”, 5mm or Best results in delivery capacity are achieved when using 5/4” (32mm) 0.5mm, except the Trash Pump Model # ST-900SD which is 1.4”, 35mm)
- Page 5 • In order to unplug, pull the plug shell not the power cable. In case of manual operation the Submersible Pump starts when the • The power cable (1) must not be used for mounting or relocating the power cable has been connected and the float switch has been lifted.
- Page 6 TECHNICAL DATA TROUBLE-SHOOTING GUIDE 9. Technical Data 10. Trouble-Shooting Guide SP-550SD SP-750TD Problem Probable Cause Remedy Pump is running Air cannot escape, since Open pressure line Rated Power 550W 750W but doesn’t deliver pressure line is closed. (e.g. kinked pressure pipe.) Max.
- Page 7 If you need assistance with the assembly or operation of your Submersible Pump please call 1-866-850-6662...